Configuring Port Authentication Introduction
6-129
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
SHOW DOT1X COUNTER
Syntax
SHOW DOT1X COUNTER [INTERFACE={type:id-range|id-range|ifname-
list|ALL}] [SUPPLICANT=macaddress-list|ALL]
[TYPE={STATISTICS|DIAGNOSTICS|SESSIONSTATISTICS|ALL}] [FULL]
Description This command is used to display the counters/statistics of supplicants which have been
authorized by 802.1X-based Port Authentication.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SHOW DOT1X COUNTER
--- Port Authentication Statistics Counters ---
ETH:6.22 : 00:09:41:58:E6:F2
---------------------------
EAPOL Rx Tx Start Logoff Invalid
2 19 0 0 0
EAP Resp/Id Response Req/Id Tx Req Tx LenErr
0 2 0 19 0
--- Port Authentication Diagnostics Counters ---
ETH:6.22 : 00:09:41:58:E6:F2
---------------------------
[Connecting] [Authenticating] [Authenticated] [Backend]
Option Description Default Value
INTERFACE The ethernet interfaces over which the authentication
parameters will be shown.
ALL
SUPPLI-
CANT
Specifies a supplicant's MAC address or ALL supplicants. ALL
TYPE The type of Counter
STATISTICS - statistics counters are displayed.
DIAGNOSTICS - diagnostics counters are displayed.
SESSIONSTATISTICS - session statistics counters are
displayed.
ALL - All types are displayed
ALL
FULL Displays more descriptive information Abbreviated
To Next Page
Loading...
