Introduction Configuring Classifiers
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
6-28
SET CLASSFIER
Syntax
SET CLASSIFIER=classifiername-list [ VID={ 1..4095 | ANY } ] [
VPRIORITY={ 0..7 | ANY } ] [ INNERVID={ 1..4095 | ANY } ] [
INNERVPRIORITY={ 0..7 | ANY } ] [ ETHFORMAT={ 802.3 | 802.3TAGGED |
802.3UNTAGGED | ETHII | ETHIITAGGED | ETHIIUNTAGGED | ANY } ] [
LSAP={ NETBIOS | lsap-value | ANY } ] [ IPDEST={ ipaddress-mask |
MULTICAST | ANY } ] [ IPSOURCE={ ipaddress-mask | ANY } ] [ IPD-
SCP={ 0..63 | ANY } ] [ IPPROTOCOL={ TCP | UDP | ICMP | IGMP |
ipprotocol-number | ANY } ] [ IPTOS={ 0..7 | ANY } ] [ MACDEST={
macaddress | MULTICAST | ANY } ] [ MACSOURCE={ macaddress | ANY } ]
[ PROTOCOL={ IPV4 | IPV6 | protocol-type | ANY } ] [ TCPPORTDEST={
tcp-port-list | ANY } ] [ TCPPORTSOURCE={ tcp-port | ANY } ] [ TCP-
FLAGS={ { URG | ACK | RST | SYN | FIN | PSH } [ ,... ] | ANY } ] [
UDPPORTDEST={ udp-port-list | ANY } ] [ UDPPORTSOURCE={ udp-port |
ANY } ]
Description Sets the match rule for the specified CLASSIFIER(s). The match rule specified in this
command replaces any existing match rule on the CLASSIFIER(s). Refer to the options
table for CREATE CLASSIFIER.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SET CLASSIFIER=ipfilt2 IPSOURCE=ANY
Option Description Default Value
CLASSFIER The already created CLASSFIER(s), separated by a
comma.
To Next Page
Loading...
Need help?
General
