Configuring Classifiers Introduction
6-29
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
SETDEFAULTS CLASSIFIER
Syntax
SETDEFAULTS CLASSIFIER=classifiername [ VID ] [ VPRIORITY ] [
INNERVID ] [ INNERVPRIORITY ] [ ETHFORMAT ] [ LSAP ] [ IPDEST ] [
IPSOURCE ] [ IPDSCP ] [ IPPROTOCOL ] [ IPTOS ] [ MACDEST ] [ MAC-
SOURCE ] [ PROTOCOL ] [ TCPPORTDEST ] [ TCPPORTSOURCE ] [ TCPFLAGS
] [ UDPPORTDEST ] [ UDPPORTSOURCE ]
Description Clears the specified user defined match rule (or rules) from the CLASSIFIER. The previ-
ous user defined match rule match rule may still exist on the CLASSIFIER as a derived
rule if it is required by any of the remaining match rules. For example, if the match rules
TCPPORTDEST=45 and IPPROTOCOL= TCP exist on a classifier then clearing IPPRO-
TOCOL will result in that rule being removed as a user defined rule and added back as a
derived rule. This command does not remove association of the CLASSIFIER to
ACTION(s) or INTERFACE(s).
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SETDEFAULTS CLASSIFIER=ipfilter3
Option Description Default Value
TRAFFICDE-
SCRIPTOR
The name(s) of the already created TRAFFICDESCRIP-
TOR(s), separated by a comma.
To Next Page
Loading...
Need help?
General
