Allied Telesis SwitchBlade x3100 Series - Configuration Procedure for User Profile

Introduction Custom Profiles
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-228
3
>SHOW PROFILE AUTOPROV=GE
--- Gigabit Ethernet Port Profiles ---
Name............................... AutoProv
Type............................... GEPORT
Initial Admin State................ Up
Auto Negotiation................... On
Speed.............................. Auto
Duplex............................. Auto
Flow Control....................... Auto
Create a Profile, gold, where all of the attributes are the same except for FLOWCONTROL. This is added to the Port
Profiles.
4
>CREATE PROFILE=GOLD GEPORT FLOWCONTROL=ON
Info (033561): Successfully created profile(s) GOLD
>SHOW PROFILE NAMES
--- Card Profiles ---
............................................
--- Port Profiles ---
Name Type
-------------------------------- --------
AutoProv GEPORT
GOLD GEPORT
AutoProv XEPORT
Associate an interface with the profile. (If necessary, disable the interface first.)The interface now has the profile
attributes.
5
>SET INTERFACE=8.0 PROFILE=gold
>SHOW INTERFACE=8.0
--- GE Interfaces ---
Interface.......................... 8.0
Type............................... GE
State.............................. UP-DN-Dependency
Description........................ <none>
Remote ID.......................... <none>
External Profile................... <none>
Card Type.......................... GE24POE
Provisioning
Provisioning Profile............ gold
Direction....................... Customer
..........................
TABLE 1-47 Configuration Procedure for User profile
Step Command Description