Introduction Common Line Card Attributes
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-232
• If the Administrative State is DOWN, the Operational State will always be DOWN.
1.17.6 Common Line Card Attributes
The attributes for a Line Card are shown in the display for the SHOW CARD <slot number> command.
Following is the output for the command. Ta b le 1 - 4 8 describes the attributes and states that are common for
Ethernet cards.
E134 - officer SEC>>>> show card 3
--- Card Information ---
Slot............................... 3
Type............................... GE24POE
State.............................. UP-UP-Online
Provisioning Profile............... AutoProv (*)
Hardware
Model Number (Revision)......... AT-SBx24POE (Rev X6)
Serial Number................... 17
CLEI Code....................... <none>
Software
Running Load.................... 14.2.0.dhays.20100325
Preferred Load.................. ge24poe_14.2.0.dhays1.20100325.tar
Temporary Load.................. <none>
.
TABLE 1-48 Common Line Card Attributes - Defaults are in Bold)
Card Attribute Values / Range Description
Slot Slot Number The slot number occupied by the card
Type Depends on the card type The type of card
To Next Page
Loading...
Need help?
General
