Allied Telesis SwitchBlade x3100 Series - Show Bfd

Configuring BFD Introduction
7-133
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
SHOW BFD
Syntax
SHOW BFD [ INTERFACE [ ={ type:id-range | id-range | ifname-list |
ALL } ] ] [ FULL ]
Description Shows the BFD configuration. For state information, the user enters the SHOW INTER-
FACE command since State information does not show up in SHOW BFD.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SHOW BFD INTERFACE ALL
--- Bi-directional Forwarding Detection Configuration Data ---
---- Protocol State ---- ------ Interval Settings ------
Interface Status Local Remote Local Remote
--------- -------- ------------ ------------ --------------- ---------------
8.18 Enabled Up Up 5 x 500 ms 5 x 500 ms
8.19 Enabled Up Up 5 x 500 ms 5 x 500 ms
8.22 Enabled Up Up 5 x 500 ms 5 x 500 ms
11.0 Enabled Up Up 5 x 500 ms 5 x 500 ms
Option Description Default Value
INTERFACE