Allied Telesis SwitchBlade x3100 Series User Manual

Introduction Password Recovery
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-48
SET SYSTEM USERCONFIG (SEC)
Syntax
SET SYSTEM USERCONFIG [ LOGINFAIL=1..10 ] [ LOCKOUTPD=0..30000 ] [
MANPWDFAIL=1..5 ] [ SECUREDELAY={ OFF | 0 | 1..90 } ]
[ MINPWDLEN=1..23 ] [ PERSISTTIMER=1..1440 ]
[ PWDAGEING={ OFF | 0 | 1..365 } ] [ FORCEPWDCHANGE={ YES | NO } ]
Description Used to modify the global (system-wide) security parameters for user authentication.
Changes to the minimum password length will affect only new users or future updates to
existing user passwords.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
LOGINFAIL Determines the maximum number of consecutive login
failures allowed before locking out a user or session.
5
LOCK-
OUTPD
Sets the number of seconds to lockout a user or session
after the maximum number of consecutive failed login
attempts were made. The maximum number of consec-
utive failed logins is defined by the LOGINFAIL parame-
ter.
SECUREDE-
LAY
Specifies the number of minutes that a user session can
remain idle before it is automatically timed out.
5
MANPWD-
FAIL
Not currently supported
SECUREDE-
LAY
Specifies the number of minutes that a user session can
remain idle before it is automatically timed out.
5
MINP-
WDLEN
Specifies the minimum number of characters a user
password is allowed to contain. This parameter affects
setting of password in CLEARTEXT format or via the
SET PASSWORD command.
6
PERSIST-
TIMER
Sets the persistence interval for system counters. The
value is specified in minute increments.
10
PWDAGE-
ING
Indicates the number of days before a password expires
and requires the user to change its password. If the
value is OFF or 0, then the password does not expire.
30
FORCEP-
WDCHANG
E
Indicates if a new user account requires a change in the
password upon the initial login of that user. If the value is
set to YES, then the user will be prompted for a new
password when they first log in.
NO

Allied Telesis SwitchBlade x3100 Series Specifications

General

Brand	Allied Telesis
Model	SwitchBlade x3100 Series
Category	Switch
Language	English