Allied Telesis SwitchBlade x3100 Series - Commands for Software Load Management

Commands for Software Load Management Introduction
1-117
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
software load is “cfc200_14.2.0.GAMMA.20100716.tar” (as previously set by the user using the SET
CARD=ACTCFC PREFLOAD command). The IP address of the designated network boot server is 10.52.65.38.
1.8.4 Commands for Software Load Management
TABLE 1-16 Procedure - Configuring the Boot Server
Step Command Description/Notes
Configure the IP address of the boot server (where preferred CFC software load resides)
1
set bootserver ipaddress 10.52.65.38 Sets the IP address of the network boot server
to 10.52.65.38
Configure the path on boot server (where preferred CFC software load is located)
2
set bootserver path x3112Files/ Sets the path (on the network boot server) to
“x3112/”
Verify the new boot server settings
3
show bootserver
-------------------------------------------------------------------------------
Network Boot Host IP..... 10.52.65.38
Network Boot Load........ cfc200_14.2.0.GAMMA.20100716.tar
Network Boot Path........ x3112Files/
TABLE 1-17 Software Load Management Commands
Commands
SET BOOTSERVER
SHOW BOOTSERVER