To Next Page

To Previous Page

Configuring DHCP Relay Introduction

7-27

Software Reference for SwitchBlade x3100 Series Switches (Network Management)

CLEAR DHCPRELAY INTERFACE

Syntax

CLEAR DHCPRELAY INTERFACE={ type:id-range | id-range | ifname-list

| ALL } { [ IPADDRESS={ ipaddress-list | ALL } ] | [ MACADDRESS={

macaddress | ALL } ] }

Description This command CLEAR DHCPRELAY allows the manual deletion of IP filters applied to

the subscriber interfaces. Note that there is no means of manually adding an IP filter to an

interface (this is performed automatically by DHCP Relay Agent, when filter is set to

"on").

Options The following table gives the range of values for each option that can be specified with

this command and a default value (if applicable).

Example

CLEAR DHCPRELAY INTERFACE=ALL

Option Description Default Value

INTERFACE A logical representation of one or more physical ports;

the INTERFACE to enable DHCP Relay service on.

type:id-range - the type of available ports, such as ETH

or LAG

id-range - used to query the physical ports; the numeri-

cal identifier of the interface

ifname-list - list of interface names; an interface name

may not be assigned to the MGMT interface, as it is

fixed as ‘MGMT'

ALL - all interfaces in the system

N/A

IPADDRESS ipaddress-list - list of assigned IP addresses

ALL - all available IP addresses

ALL

MAC-

ADDRESS

The MAC address is a unique serial number that identi-

fies a network element.

ALL - all MAC addresses

ALL

Allied Telesis SwitchBlade x3100 Series User Manual

Questions and Answers: