Introduction Configuring LLDP
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
7-84
DELETE LLDP INTERFACE OPTIONS
Syntax
DELETE LLDP INTERFACE={ type:id-range | id-range | ifname-list |
ALL }
OPTIONS
[ PORTDESC ] [ SYSNAME ] [ SYSDESC ] [ SYSCAP ] [ PORTVLAN ] [ VLAN-
NAME ] [ PROTOVLAN ] [ PROTOCOL ] [ MACPHYCONFIGSTATUS ] [ POWERVI-
AMDI ] [ LINKAGGREGATION ] [ MAXFRAMESIZE ] [ EPSR ] [ UCP ] [ ALL ]
Description Deletes one or more OPTIONS to the Interface(s) for LLDP. Note that this command
does not disable LDP (that is the SET LLDP INTERFACE MODE command), but deletes
specified OPTIONS.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
DELETE LLDP INTERFACE=0.0, 3.22 OPTIONS=UCP
SHOW LLDP INTERFACE=0.0
--- LLDP Information ---
Interface.......................... 0.0
Mode............................... Off
SNMP Notifications................. Disabled
TLVs Enabled for Transmit.......... None
Local Interface Data
Port ID......................... Interface Name:
ETH:0.1
Port Description................ ETH:0.1
Option Description Default Value
INTERFACE A logical representation of one or more physical ports;
the INTERFACE for which RMON data is enabled
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - used to specify the same historical data collection
parameters on all applicable interfaces in the system
OPTIONS Refer to Table 7-11.
To Next Page
Loading...
Need help?
General
