Configuring LLDP Introduction
7-85
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
RESET LLDP COUNTER
Syntax
RESET LLDP COUNTER
[ INTERFACE={ type:id-range | id-range | ifname-list | ALL } ]
Description Allows the user to clear the LLDP interface counters. data (local system LLDP counters)
for each interface specified. If the INTERFACE parameter is not provided, then all inter-
faces are reset.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
RESET LLDP COUNTER INTERFACE=ALL
Option Description Default Value
INTERFACE A logical representation of one or more physical ports;
the INTERFACE for which RMON data is enabled
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - used to specify the same historical data collection
parameters on all applicable interfaces in the system
ALL
To Next Page
Loading...
