Introduction Configuring Port Authentication
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
6-132
SHOW DOT1X SUPPLICANT
Syntax
SHOW DOT1X SUPPLICANT[=macaddress-list|ALL] [INTERFACE={type:id-
range|id-range|ifname-list|ALL}] [FULL]
Description This command is used to display the current status of a supplicant which has been autho-
rized by 802.1X-based Port Authentication.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SHOW DOT1X SUPPLICANT
--- Port Authentication Supplicant ---
Number of Supplicants................. 1
Number of Authorized Supplicants...... 0
--- Port Authentication Supplicant ---
Interface UserName Type VLAN Status MacAddress
--------- ----------------- --------- ---- -------------- -----------------
ETH:6.22 user1 802.1X 301 Authenticating 00:09:41:58:E6:F2
Option Description Default Value
SUPPLI-
CANT
Specifies a supplicant's MAC address or ALL supplicants. ALL
INTERFACE The ethernet interfaces over which the supplicant
parameters will be shown.
ALL
FULL Displays more descriptive information Abbreviated
To Next Page
Loading...
