Allied Telesis SwitchBlade x3100 Series - Page 694

Introduction Configuring Port Authentication
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
6-134
SHOW TRACE AUTHENTICATION
Syntax
SHOW TRACE AUTHENTICATION [INTERFACE={type:id-range|id-range|
ifname-list|ALL}] [TYPE={DOT1X}] [EVENT={{SUCCESS|FAILURE|LOGOFF}
[,...]|ALL}]
Description Shows various tracing parameters for Port Authentication.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SHOW TRACE AUTHENTICATION
--- Auth Message Trace ---
Interface Type Event
--------- --------- --------------------------------------------------------
ETH:11.19 802.1X Success,Failure,Logoff
Option Description Default Value
INTERFACE The ethernet interfaces over which the trace parame-
ters will be shown.
ALL
TYPE The type of authentication. In release 14.2, only DOT1X
is supported.
DOT1X
EVENT Specifies the type of Port Authentication event to add:
SUCCESS - Authentication has succeeded, and so a data
session can begin.
FAILURE - Authentication has failed.
LOGOFF - The supplicant has logged off, and the port
returns to an unauthorized state.
ALL