Allied Telesis SwitchBlade x3100 Series User Manual

Introduction Configuring IGMP
Software Reference for SwitchBlade x3100 Series Switches (Internet Group Management
Protocol (IGMP))
5-24
SHOW IGMPSNOOPING
Syntax
SHOW IGMPSNOOPING
[ { STATUS | MCASTGROUPS [ FULL ] | COUNTER
[ { STANDARD | MESSAGERESPONSE | INTERFACE={ type:id-range | id-
range | ifname-list | ALL } |
CARD={ slot-list | ALL } } ] |
INTERFACE={ type:id-range | id-range | ifname-list | ALL }
[ FULL ] |
CARD={ slot-list | ALL } [ FULL ] } ]
Description The SHOW IGMPSNOOPING command is used to display the current status of the
IGMP snooping feature, the currently configured value of the IP multicast stream count
value, or the set-top box (STB) MAC address(es) that have been configured for a partic-
ular port in the system or for all of the ports in the system.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
manager SEC>> show igmp INTERFACE eth:11.*
Processing....
--- Interface IGMP Snooping Status/Multicast (MC) Groups ---
Provisioned Learned MC Subscriber
Interface Status Snooping Mode MAC Count MAC Count Group Count
-------------- -------- -------------- ------------ ----------- -------------
ETH:11.0 Enabled Internal 0 0 0
ETH:11.1 Enabled Internal 0 0 0
ETH:11.2 Enabled Internal 0 0 0
ETH:11.3 Enabled Internal 0 0 0
Option Description Default Value
STATUS Display the IGMP status information
COUNTER The type of IGMP snooping counter to show:
CARD -
STANDARD -
MESSAGERESPONSE -
INTERFACE -
INTERFACE The interfaces against which to show IGMP information.
CARD The card against which to show IGMP information.
ALL - All provisioned cards
FLOODING

Allied Telesis SwitchBlade x3100 Series Specifications

General

Brand	Allied Telesis
Model	SwitchBlade x3100 Series
Category	Switch
Language	English