Introduction Configuring the Egress Port Rate Limiting
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
6-62
ADD EGRESSLIMITER INTERFACE
Syntax
ADD EGRESSLIMITER=limitername INTERFACE={ type:id-range | id-range
| ifname-list | ALL }
Description Associates an EGRESSLIMITER with one or more INTERFACEs. This limits the traffic
that the system transmits through this INTERFACE to the values specified by the
EGRESSLIMITER. A particular INTERFACE may only be associated with one EGRESSLIM-
ITER, but a particular EGRESSLIMITER may be associated with any number of ports.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
ADD EGRESSLIMITER=sub_gold INTERFACE=ETH:7.0
Option Description Default Value
EGRESSLIM-
ITER
The name of the EGRESSLIMITER that is being added to
the INTERFACE(s).
INTERFACE The interface the EGRESSLIMITER will be associated
with.
To Next Page
Loading...
