Introduction Configuring LLDP
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
7-78
REINITDELAY 1..10 (2)
(in seconds)
Determines the time in seconds for when a MSAP identifier state is
allowed to go from a LLDP disabled state to a transmit enabled state
again. It is not applicable the first time when the MSAP identifier goes
from a disabled state to a transmit enable state.
NOTIFYINTERVAL 1-3600 (5)
(in seconds)
Determines the delay in seconds before successive unsolicited notifi-
cations are sent to the NMS from a network port whose NMS notifi-
cation status option (NOTIFY) is enabled.
The use of this parameter results in only one trap being sent to the
NMS even if multiple traps are generated within the NMS notification
interval for a network port whose NMS notification status parameter
is enabled.
TABLE 7-9 System-Wide Protocol Configuration Options for LLDP
Parameter Range Description
To Next Page
Loading...
Need help?
General
