Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
• The piston -2- moves upwards and the release tabs -1- on
puller - T40148- spread apart -arrows-.
– Use puller - T40148- to pull cigarette lighter out of illuminated
ring.
– Unplug electrical connector.
Installing
Installation is carried out in the reverse order; note the following:
Caution
Risk of injury.
♦ After detaching puller - T40148- check that retaining tabs
for lighter are not bent.
♦ If retaining tabs are bent they must be bent back to prevent
lighter from ejecting.
– Detach support -1- from puller - T40148- .
– Push piston downwards and hold in this position.
– Turn knurled wheel -4- on puller - T40148- anti-clockwise
-arrow-; this will open release tabs -2- on cigarette lighter
-item 3- and puller - T40148- can be removed.
2.4 Removing and installing cigarette lighter
illumination bulb - L28-
– Remove 12 V socket ⇒ page 99 .
– Release retaining clips in direction of -arrows-.
– Take illuminated ring -1- with cigarette lighter illumination bulb
out of rear trim panel -2- for centre console.
Installing
Installation is carried out in the reverse order; note the following:
– Illuminated ring can only be fitted in one position into mounting.
– Install 12 V socket ⇒ page 99 .
2.5 Removing and installing 12 V socket -
U18- / -U19- in long centre console
Special tools and workshop equipment required
Audi A8 2003 ➤
Electrical system - Edition 08.2014
100 Rep. gr.90 - Gauges, instruments
To Next Page
Loading...
