Audi 2003 A8 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Multi-pin connector, 4-pin
1 - Easy Entry facility
2 - Steering column adjustment switch
3 - Terminal 31
4 - Not used
22.8 Removing and installing turn signal
switch - E2-
Removing
– Remove steering column switch module ⇒ page 243 .
Note
Return ring with slip ring must be removed/installed in centre po‐
sition (wheels in straight ahead position).
– Carefully release retaining hooks -arrows-.
– Detach return ring with slip ring -2- and steering angle sender
- G85- -item 1- from steering column switch module.
– Unscrew bolts -arrows-.
– Remove steering column electronics control unit - J527-
-item 2- and intermittent wiper switch - E22- -item 3- from
steering column switch module.
– Detach cruise control system switch - E45- -item 1- at steering
column switch module.
– Unscrew bolt -5- and remove retaining clip -4-.
Installing
Installation is carried out in the reverse order; note the following:
– Make sure all retaining hooks and the electrical connectors are
properly engaged.
– Install steering column switch module ⇒ page 243 .
Tightening torques
Component Nm
Steering column switch module to steering col‐
umn electronics control unit - J527-
0.65
Intermittent wiper switch - E22- to steering col‐
umn electronics control unit - J527-
0.65
Cruise control system switch - E45- at steering
column switch module and steering column
electronics control unit - J527-
0.65
Audi A8 2003 ➤
Electrical system - Edition 08.2014
250 Rep. gr.94 - Lights, bulbs, switches - exterior

Audi 2003 A8 Specifications

General

Brand	Audi
Model	2003 A8
Category	Automobile
Language	English