Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Use removal lever - 80 - 200- to carefully pry off cover panel
of interior light/reading light as shown.
– Take glass base bulb -1- (12 V, 6 W) out of clamp-type holder.
Installing
Installation is carried out in the reverse order; note the following:
– Press on lens for interior light until it engages.
7.10 Renewing rear reading light bulb - vehi‐
cles up to 08.2007
Removing
– Remove interior light/reading light (rear) ⇒ page 296 .
– Release retaining tabs -arrows- and swivel bulb holder out of
mounting.
– Take glass base bulb (12 V, 6 W) out of clamp-type holder.
Installing
Installation is carried out in the reverse order; note the following:
– Insert rear interior light/reading light into roof trim and clip into
place.
7.11 Removing and installing rear interior
light/reading light with rear operating
unit for roof module - E467- - vehicles
from 09.2007 onwards
Special tools and workshop equipment required
Audi A8 2003 ➤
Electrical system - Edition 08.2014
298 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
