Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6 Side marker light (USA vehicles)
6.1 Removing and installing side marker
light
Special tools and workshop equipment required
♦ Removal lever - 80 - 200-
♦ Adhesive tape
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
– Mask bumper cover on inside of side marker light with an ad‐
hesive strip -1-.
– Use removal lever - 80 - 200- to prise up side marker light
approx. 10 mm as shown in illustration.
– Slide side marker light towards centre of vehicle on adhesive
strip -arrow- until side marker light with electrical connector
can be taken out of bumper cover.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
198 Rep. gr.94 - Lights, bulbs, switches - exterior
To Next Page
Loading...
