Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4.3 Unplugging door separating connector
(left-side)
Procedure
– Press dust cover -1- at location marked with -arrow- and de‐
tach.
– Release door separating connector -1- and remove outwards
-arrow- (press retainer tab -2-).
– Make sure connector is pressed onto connection piece so it
engages audibly.
– Press on dust cover so it engages audibly.
Note
Make sure sealing lip of dust cover makes contact with A pillar
evenly all round.
4.4 Removing and installing onboard supply
control unit - J519-
Removing
– If control unit is to be renewed, select the “Replace control unit”
function for appropriate control unit in ⇒ Vehicle diagnostic
tester.
– Continue to follow the instructions on the display of the vehicle
diagnostic tester.
– Switch off ignition and take out ignition key.
– Remove driver's storage compartment ⇒ Rep. gr. 68 .
– Remove heating duct in driver's footwell.
– Detach onboard supply control unit - J519- from mounting
frame in direction of -arrow-.
– Unplug electrical connectors on onboard supply control unit.
Installing
Installation is carried out in the reverse order; note the following:
– Install driver's storage compartment ⇒ Rep. gr. 68 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
340 Rep. gr.97 - Wiring
To Next Page
Loading...
