Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.12 Removing and installing door warning
lamp and entry light
Removing
– Use flat screwdriver to press in retaining tab -1- and pry out
door warning lamp/entry light -2-.
– Unplug electrical connector -3-.
– If fitted, carefully pry off cover at door warning lamp -arrow-.
– Take bulb -1- (12 V, 3 W) on back of door warning lamp/entry
light out of bulb holder -2-.
Installing
Installation is carried out in the reverse order; note the following:
– If fitted previously, attach cover at door warning lamp.
– Insert door warning light/entry light in opening and engage on
opposite side.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Lights and switches in front doors 281