Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
20 High-level brake light
20.1 Removing and installing high-level
brake light
Special tools and workshop equipment required
♦ Removal lever - 80 - 200-
Removing
– Do not press brake pedal.
– Use removal lever - 80 - 200- to prise cover grille with high-
level brake light out of rear shelf -arrow 1-.
– Pull out cover grille to front -arrow 2-.
– Unplug electrical connector -1- at high-level brake light -2-.
– Unscrew bolts -arrows-.
– Detach high-level brake light from cover grille.
Note
Entire high-level brake light must be renewed if the LED is de‐
fective.
Installing
Install in reverse order.
Tightening torque
Component Nm
High-level brake light to cover grille 3
Audi A8 2003 ➤
Electrical system - Edition 08.2014
240 Rep. gr.94 - Lights, bulbs, switches - exterior
To Next Page
Loading...
