Audi 2003 A8 - Removing and Installing Alternator; Vehicles with 3.0 Ltr. MPI Engine

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3 Removing and installing alternator
Observe notes on contact corrosion ⇒ page 1 .
3.1 Vehicles with 3.0 ltr. MPI engine
Special tools and workshop equipment required
♦ Poly V-belt lever - 3299- with -3299/1-
♦ Drip tray for workshop hoist - VAS 6208-
Removing
– With ignition switched off, disconnect earth cable at battery
⇒ page 2 .
– Pull off engine cover (front) -arrows-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
10 Rep. gr.27 - Starter, current supply, CCS