Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
Before removing, mark running direction of poly V-belt with chalk
or felt-tipped pen. If the poly V-belt runs in the opposite direction
when it is refitted, this can cause breakage.
– To slacken poly V-belt, swivel tensioner in direction of
-arrow- using poly V-belt lever - 3299- with -3299/1- .
– Detach poly V-belt from power steering pump pulley.
– Release pressure from tensioner.
WARNING
Hot steam/hot coolant may escape when opening coolant ex‐
pansion tank. Cover cap with cloth and open carefully.
– Open filler cap for coolant expansion tank.
– On vehicles with auxiliary heater, unscrew bolts -arrows- for
exhaust pipe of auxiliary/supplementary heater at noise insu‐
lation.
– Open quick-release fasteners -1- and detach front noise insu‐
lation. Leave rear noise insulation in position.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Removing and installing alternator 11
To Next Page
Loading...
