Audi 2003 A8 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
23 Entry and start authorisation switch -
E415-
Note
♦ Reader coil for immobiliser is attached to entry and start au‐
thorisation switch - E415- and cannot be renewed separately.
♦ The entry and start authorisation switch - E415- must be re‐
newed if reading coil is defective.
23.1 Removing and installing entry and start
authorisation switch - E415-
Note
♦ Adaption to immobiliser is not necessary if the entry and start
authorisation switch - E415- is renewed.
♦ The lock in the entry and start authorisation switch - E415- is
not mechanically coded.
♦ Therefore the keys must not be renewed after renewing entry
and start authorisation switch -E415- (continue to use old
keys).
Special tools and workshop equipment required
♦ Socket tool - T10152-
Removing
– Switch off ignition and take out ignition key.
WARNING
When working on knee airbag, observe safety precautions for
working on airbags ⇒ Rep. gr. 69 .
– Remove driver's storage compartment ⇒ Rep. gr. 68 .
– Use small screwdriver to prise off trim ring at entry and start
authorisation switch -arrow-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
23. Entry and start authorisation switch E415 253

Audi 2003 A8 Specifications

General

Brand	Audi
Model	2003 A8
Category	Automobile
Language	English