Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug electrical connector -1-.
– Use small screwdriver to carefully release retaining hooks
-arrows-.
– Pull driver seat/front passenger seat memory operating unit
-2- downwards out of switch mounting.
Installing
Installation is carried out in the reverse order; note the following:
– Press driver seat/passenger seat memory operating unit into
switch mounting until retaining hooks engage.
– Install door trim (front) ⇒ Rep. gr. 70 .
3.9 Removing and installing emergency-off
button -E190- / -E466- for driver seat/
front passenger seat memory operating
unit
Removing
– Switch off ignition and take out ignition key.
– Remove door trim (front) ⇒ Rep. gr. 70 .
– Detach insulating mat from door trim.
– Unscrew bolts -arrows- and detach loudspeaker trim.
– Unplug electrical connector -1-.
– Unscrew bolts -arrows- and detach storage compartment from
door trim.
– Use Allen key to remove pin -1- for actuation of storage com‐
partment lock and pin -2- for stop.
– Repeat procedure on other side of storage compartment.
– Open storage compartment.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
278 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
