Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unscrew bolt -arrow- and remove front ashtray housing.
– Unplug electrical connector.
– Lift off switch trim for centre console -arrows-.
– Unplug electrical connectors.
– Unscrew bolt -arrow-.
– Remove the interior aerial 1 for entry and start authorisation -
R138- -item 1-.
Installing
Install in reverse order.
Tightening torques
Component Nm
Interior aerial 1 for entry and start authorisation
- R138- to switch trim
0.8
Ashtray housing to centre console 2.5
10.7 Removing and installing entry and start
authorisation control unit - J518-
♦ Fitting location: beneath floor covering under driver's seat
Removing
– To renew control unit, select the “Replacement” function for
the appropriate control unit in “Guided Fault Finding” ⇒ Vehicle
diagnostic tester.
– Remove driver's seat ⇒ Rep. gr. 72 .
– Switch off ignition and take out ignition key.
– Remove lower A-pillar and B-pillar trim ⇒ Rep. gr. 70 .
– Fold back floor covering.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
312 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
