Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
With this programme the headlights return to the basic setting.
– Continue to follow the instructions on the display of the vehicle
diagnostic tester.
– You will be requested to perform headlight adjustment while
running through the programme.
Headlight (left-side)
Adjuster screws on left headlight:
1 - Height/lateral adjuster screw
2 - Height adjuster screw
The arrangement on the right headlight is symmetrically opposite.
– Only turn adjuster screw -2- to adjust the height.
– To make a lateral adjustment, turn adjuster screws -1- and
-2- the same number of turns.
4.5 Preparations for headlight bulb replace‐
ment
Depending on the engine version, access to the headlight bulbs
could be obstructed. In this case, additional steps must be per‐
formed.
4.5.1 Removing power steering reservoir
Special tools and workshop equipment required
♦ Used oil collection and extraction unit - V.A.G 1782-
Procedure
– Use oil collection and extraction unit - V.A.G 1782- to draw off
hydraulic fluid for power steering from reservoir.
Note
Place cloth under power steering reservoir to catch escaping hy‐
draulic fluid.
– Remove power steering reservoir.
Installation is carried out in the reverse order; note the following:
Audi A8 2003 ➤
Electrical system - Edition 08.2014
152 Rep. gr.94 - Lights, bulbs, switches - exterior
To Next Page
Loading...
Need help?
General
