Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug electrical connectors -1- and -2- at bulb holder -3- with
bulb.
Installing
Installation is carried out in the reverse order; note the following:
Note
Flat side of flat connector must face bulb holder with bulb.
– Install inner tail light cluster ⇒ page 233 .
Tightening torques
Component Nm
Bulb holder with bulb to tail light cluster 1
Housing cover to tail light cluster 1
19.5 Aligning tail light cluster with body con‐
tour
Procedure
– Remove rear lid trim ⇒ Rep. gr. 70 .
Adjustment at right angles to direction of travel:
– Unscrew nuts -2, 3, 4- and move tail light cluster as required.
Adjustment in direction of travel:
– After unscrewing nut -1-, screw centre hex stud -2- in or out.
– Install rear lid trim ⇒ Rep. gr. 70 .
– After unscrewing nuts -2, 3, 4-, screw centre hex stud -1- in or
out at hexagon head.
Tightening torque
Component Nm
Tail light cluster to rear lid 3
Audi A8 2003 ➤
Electrical system - Edition 08.2014
19. Inner tail light cluster - vehicles from 09.2007 onwards 239
To Next Page
Loading...
