Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
5.6 Renewing gas discharge bulb
WARNING
High voltage! Danger to life! Observe environmental require‐
ments.
♦ Safety precautions when handling gas discharge bulbs ⇒
Electrical system; General information; Rep. gr. 94 ; Safe‐
ty precautions when handling gas discharge bulbs
WARNING
High voltage! Danger to life!
♦ Ensure that any part of the gas discharge headlights
marked with yellow high-voltage warning symbols are de-
energised when you are working on them.
♦ Switch off ignition and all electrical equipment and remove
ignition key.
♦ Do not flash the headlights.
Removing
– Turn light switch to position “0”.
– Switch off ignition and all electrical equipment and remove ig‐
nition key.
– Do not flash the headlights.
– Remove starter unit for gas discharge bulb: vehicles up to
08.2007 ⇒ page 159 , vehicles from 09.2007 onwards
⇒ page 161 .
– Disengage retaining clips -1-.
– Pull gas discharge bulb -2- out of headlight housing.
Installing
Installation is carried out in the reverse order; note the following:
– Install starter unit for gas discharge bulb: vehicles up to
08.2007 ⇒ page 186 , vehicles from 09.2007 onwards
⇒ page 187 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
5. Gas discharge headlights - USA vehicles 185
To Next Page
Loading...
