Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
All vehicles (continued):
– Release retaining tabs -arrows- and detach main beam hous‐
ing cover from headlight housing.
– Turn bulb holder anti-clockwise -arrow- and pull out of head‐
light housing.
– Pull main beam bulb -1- out of bulb holder -2-.
Installing
Installation is carried out in the reverse order; note the following:
Installation is carried out in the reverse order; note the following:
– Insert new bulb in bulb holder, taking care not to touch glass
bulb with bare hands.
– Secure bulb holder by turning clockwise.
– Close housing cover.
3.7 Renewing parking light bulb
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
Headlight (left-side):
– Remove power steering reservoir ⇒ page 141 .
Headlight (right-side):
– Remove air cleaner (top section) ⇒ page 142 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
144 Rep. gr.94 - Lights, bulbs, switches - exterior
To Next Page
Loading...
