Audi 2003 A8 - Renewing Rear Reading Light Bulb - Vehicles from 09.2007 Onwards; Removing and Installing LED for Background Light (Rear); Removing and Installing Illuminated Vanity Mirror (Rear)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7.13 Renewing rear reading light bulb - vehi‐
cles from 09.2007 onwards
Removing
– Remove interior light/reading light (rear) ⇒ page 298 .
– Release retaining tabs -arrows- and swivel bulb holder out of
mounting.
– Take glass base bulb (12 V, 6 W) out of clamp-type holder.
Installing
Installation is carried out in the reverse order; note the following:
– Install interior light/reading light (rear) ⇒ page 298 .
7.14 Removing and installing LED for back‐
ground light (rear)
The LEDs for background lighting (rear) are part of the rear op‐
erating unit for roof module - E467- and cannot be renewed
separately in the event of a fault.
– Renew rear interior light ⇒ page 296 .
7.15 Removing and installing illuminated
vanity mirror (rear)
Special tools and workshop equipment required
♦ Front-end hook - 3370-
Removing
– Use front-end hook - 3370- to carefully detach front side of rear
vanity mirror housing.
– Swivel down front of vanity mirror and remove from headliner
opening.
– Unplug electrical connector.
Installing
Install in reverse order.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
300 Rep. gr.96 - Lights, bulbs, switches - interior