Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7.5 Removing and installing garage door
operating unit - E284-
Garage door operating unit - E284- is part of front interior light and
cannot be renewed separately in the event of a fault.
– Renewing front interior light
⇒ “7.2 Removing and installing front interior light with roof
electronics control unit J528 - vehicles up to 08.2007”,
page 292 ,
⇒ “7.3 Removing and installing front interior light with roof
electronics control unit J528 - vehicles from 09.2007 on‐
wards”, page 293 .
7.6 Renewing bulbs for reading light (front)
♦ Fitting location: on underside in interior mirror
Removing
– Release retainer tab at lens -2- for reading light and unclip
downwards.
– Wrap adhesive tape around tips of flat-nose pliers and pull
glass base bulb -1- (12 V, 5 W) out of bulb holder.
Installing
Installation is carried out in the reverse order; note the following:
– Insert lens for reading light and press on until it engages.
7.7 Removing and installing LED for back‐
ground light (front)
The LEDs for background light (front) are part of the interior mirror
and cannot be renewed separately in the event of a fault.
– Renew interior mirror ⇒ Rep. gr. 68 .
7.8 Removing and installing rear interior
light/reading light with rear operating
unit for roof module - E467- - vehicles up
to 08.2007
Special tools and workshop equipment required
♦ Removal lever - 80 - 200-
Audi A8 2003 ➤
Electrical system - Edition 08.2014
296 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
