Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug electrical connectors -1- and -2- at bulb holder -3- with
bulb.
Installing
Installation is carried out in the reverse order; note the following:
Note
Flat side of flat connector must face bulb holder with bulb.
– Install inner tail light cluster ⇒ page 233 .
Tightening torques
Component Nm
Bulb holder with bulb to tail light cluster 1
Housing cover to tail light cluster 1
19.4 Removing and installing bulb for rear fog
light
Removing
– Remove inner tail light cluster ⇒ page 233 .
– Remove bolts -arrows- and detach housing cover -1-.
– Unscrew bolts -arrows- and detach bulb holder -1- with bulb.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
238 Rep. gr.94 - Lights, bulbs, switches - exterior
To Next Page
Loading...
