Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
18.4 Removing and installing LED printed cir‐
cuit boards and tail light control unit
Note
If LED is defective, LED printed circuit boards must be renewed
together with control unit.
Removing
– Remove inner tail light cluster ⇒ page 233 .
– Press catches apart -arrows- and detach housing cover.
– Unplug electrical connector.
– Unscrew bolts -1 … 3- and take LED printed circuit boards with
control unit out of tail light cluster.
Installing
Installation is carried out in the reverse order; note the following:
– Install inner tail light cluster ⇒ page 233 .
Tightening torque
Component Nm
LED printed circuit boards and tail light control
unit
1
18.5 Aligning tail light cluster with body con‐
tour
Procedure
– Remove rear lid trim ⇒ Rep. gr. 70 .
Adjustment at right angles to direction of travel:
– Unfasten nut -1- and move tail light cluster as required.
Adjustment in direction of travel:
– Screw adjusting nuts -2- in/out after unfastening nut -1-.
– Install rear lid trim ⇒ Rep. gr. 70 .
Tightening torque
Component Nm
Tail light cluster to rear lid 3
Audi A8 2003 ➤
Electrical system - Edition 08.2014
18. Inner tail light cluster - USA vehicles up to 08.2007 235
To Next Page
Loading...
