Audi 2003 A8 - Renewing Rear Interior Light Bulb - Vehicles from 09.2007 Onwards

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Removal lever - 80 - 200-
Removing
– Use removal lever - 80 - 200- to carefully pry off interior light/
reading light -1- -arrow- as shown in illustration.
– Press retaining tab -1- at multi-pin connector.
– Release retaining clips of connectors -arrow- and unplug con‐
nectors.
Installing
Installation is carried out in the reverse order; note the following:
– Insert rear interior light/reading light into roof trim and clip into
place.
7.12 Renewing rear interior light bulb - vehi‐
cles from 09.2007 onwards
Removing
– Remove interior light/reading light (rear) ⇒ page 298 .
– Unscrew bulb holder -1- or -2- from interior light/reading light
-3-.
Installing
Installation is carried out in the reverse order; note the following:
– Install interior light/reading light (rear) ⇒ page 298 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
7. Lights and switches in roof trim 299