Audi 2003 A8 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.4.5 Removing right air cleaner (top section)
- vehicles with 8-cyl. TDI engine
Procedure
– Remove cover for suspension strut turret (right-side) by de‐
taching spreader clip -1- and unscrewing bolt connection -2-.
– Pull cover out of retainers -arrows-.
– Remove bolts -arrows- and detach right air cleaner (top sec‐
tion).
Install in reverse order.
2.5 Renewing bulb for dipped beam head‐
lights
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
– Remove appropriate front wheel.
– Remove relevant front wheel housing liner ⇒ Rep. gr. 66 .
– Loosen locking bolt -1- a few turns.
– Release retaining tabs -arrows- and detach housing cover for
dipped beam headlights from headlight housing.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
132 Rep. gr.94 - Lights, bulbs, switches - exterior

Audi 2003 A8 Specifications

General

Brand	Audi
Model	2003 A8
Category	Automobile
Language	English