Audi 2003 A8 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4 Headlight washer system
4.1 Removing and installing headlight
washer jets
Removing
– Switch off ignition and take out ignition key.
– Remove front bumper cover ⇒ Rep. gr. 63 .
– Unplug electrical connector -1-.
– Press release tab and detach fluid hose -4-.
– Unscrew bolts -2- and remove washer jet -3-.
Installing
Installation is carried out in the reverse order; note the following:
– Install front bumper cover ⇒ Rep. gr. 63 .
Tightening torque
Component Nm
Washer jet to bumper cover 3
4.2 Adjusting washer jets
Note
The washer jets are pre-set at the factory and do not have to be
adjusted following installation.
4.3 Removing and installing washer fluid
reservoir
Note
The washer fluid reservoir supplies both the windscreen and
headlight washer systems, and is located in the front right wheel
housing. Removing and installing ⇒ page 120 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
4. Headlight washer system 123

Audi 2003 A8 Specifications

General

Brand	Audi
Model	2003 A8
Category	Automobile
Language	English