Audi 2003 A8 - Removing and Installing Glove Compartment Light; Removing and Installing Glove Compartment Light Switch E26; Removing and Installing Footwell Light (Front)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.5 Removing and installing glove compart‐
ment light
Removing
– Turn light switch to position “0”.
– Use a flat screwdriver to press in retaining tab -1- and pry out
glove compartment light -2-.
– Unplug electrical connector -3-.
– Take bulb (12 V, 5 W) on reverse side of glove compartment
light out of bulb holder.
Installing
Installation is carried out in the reverse order; note the following:
– Insert glove compartment light in opening and engage on op‐
posite side.
2.6 Removing and installing glove compart‐
ment light switch - E26-
Removing
– Switch off ignition and take out ignition key.
– Remove glove box ⇒ Rep. gr. 68 .
– Unplug electrical connector -2-.
– Pull out hinge pin -1-.
– Open removed glove box.
– Release switch -3- in anti-clockwise direction -arrow- and de‐
tach.
Installing
Installation is carried out in the reverse order; note the following:
– Install glove box ⇒ Rep. gr. 68 .
2.7 Removing and installing footwell light
(front)
Note
On vehicles with LED footwell light, the entire footwell light must
be renewed if the LED is defective.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
268 Rep. gr.96 - Lights, bulbs, switches - interior