Audi 2003 A8 - Removing and Installing Fuse Holder at Dash Panel (Right-Side)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Release cover for electronics box (driver's side) -arrows- and
fold aside.
– Take control units -1- out of electronics box (driver's side)
-2-.
– Take out electronics box.
Note
Exact assignment of contacts in driver's side electronics box can
be found in appropriate current flow diagram ⇒ Current flow dia‐
grams, Electrical fault finding and Fitting locations.
Installing
Installation is carried out in the reverse order; note the following:
– Install lower A-pillar trim ⇒ Rep. gr. 70 .
– Install driver's seat ⇒ Rep. gr. 72 .
4.7 Removing and installing fuse holder at
dash panel (right-side)
Removing
– With ignition switched off, disconnect earth cable at battery
⇒ page 2 .
– Remove glove box ⇒ Rep. gr. 68 .
– Unscrew bolts -1- for fuse holder -2-.
– Release retaining tabs and detach fuse holder from central
tube for dash panel.
– Cut open cable tie -1-.
– Release cover for fuse holder -arrows-.
– Detach fuses at fuse holder.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
342 Rep. gr.97 - Wiring