Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Carefully prise lenses -1- out of interior light on front edge us‐
ing removal lever - 80 - 200- as shown in illustration.
– Pry out switch trim with removal lever - 80 - 200- as shown in
illustration.
– Unscrew bolts -arrows-.
– Pivot front interior light downwards and remove from roof trim.
– Unplug multi-pin connector.
– Press retaining tab -1- at multi-pin connector.
– Release retaining clips of connectors -arrow- and unplug con‐
nectors.
– Unplug remaining electrical connectors.
Installing
Installation is carried out in the reverse order; note the following:
– Fit interior light and secure.
Tightening torque
Component Nm
Interior light to roof trim 4.5
7.3 Removing and installing front interior
light with roof electronics control unit -
J528- - vehicles from 09.2007 onwards
Special tools and workshop equipment required
Audi A8 2003 ➤
Electrical system - Edition 08.2014
7. Lights and switches in roof trim 293