Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Removal lever - 80 - 200-
Removing
– If control unit is to be renewed, select the “Replace control unit”
function for appropriate control unit in ⇒ Vehicle diagnostic
tester.
– Continue to follow the instructions on the display of the vehicle
diagnostic tester.
– Switch off ignition and take out ignition key.
– Carefully prise lenses -1- out of interior light on front edge us‐
ing removal lever - 80 - 200- as shown in illustration.
– Remove bolts -2-.
– Pry out front interior light -1- with removal lever - 80 - 200- as
shown in illustration.
– Pivot front interior light downwards and remove from roof trim.
– Unplug multi-pin connector.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
294 Rep. gr.96 - Lights, bulbs, switches - interior