Audi 2003 A8 - Removing and Installing Tail Light Control Unit; Aligning Tail Light Cluster with Body Contour

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unscrew bolts -1 ... 5-.
– Take LED printed circuit boards out of tail light cluster.
Installing
Installation is carried out in the reverse order; note the following:
– Install outer tail light cluster ⇒ page 220 .
Tightening torque
Component Nm
LED printed circuit board to tail light cluster 1
14.4 Removing and installing tail light control
unit
Removing
– Remove outer tail light cluster ⇒ page 220 .
– Press catches apart -arrows- and detach housing cover.
– Unplug electrical connector.
– Unscrew bolts -arrows- and detach tail light control unit from
housing cover for tail light cluster.
Installing
Installation is carried out in the reverse order; note the following:
– Install outer tail light cluster ⇒ page 220 .
Tightening torque
Component Nm
Tail light control unit to housing cover 1
14.5 Aligning tail light cluster with body con‐
tour
Adjustment in direction of travel:
– Gradually screw retaining pin -arrow- in/out with tail light clus‐
ter removed ⇒ page 220 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
14. Outer tail light cluster - vehicles up to 08.2007 221