Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Do not flash the headlights.
– Loosen locking bolt -1- a few turns.
– Remove appropriate front wheel.
– Remove relevant front wheel housing liner ⇒ Rep. gr. 66 .
– Release retaining tabs -arrows- and detach housing cover for
dipped beam headlights from headlight housing.
– Unplug electrical connector.
– Unscrew bolts -arrows- and detach output module for head‐
light from housing cover.
– Release retaining tabs -arrows A- and press connector -1- out
of housing cover -2- -arrow B-.
– Detach housing cover.
Installing
Installation is carried out in the reverse order; note the following:
– Check seal between output module for headlight and housing
cover.
– Re-attach connector.
– Close housing cover and secure with locking bolt.
– Install front wheel housing liner ⇒ Rep. gr. 66 .
Tightening torque
Component Nm
Output module to headlight 1
5.20 Renewing headlight holders
Note
Broken headlight holders (e.g. accident damage) can be renewed
separately. In many cases this avoids having to renew the entire
headlight.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
196 Rep. gr.94 - Lights, bulbs, switches - exterior
To Next Page
Loading...
