Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
9 Turn signal repeaters - vehicles up to
08.2007
9.1 Removing and installing turn signal re‐
peater
Removing
– Switch off ignition and take out ignition key.
– Unfasten and push aside rear section of front wheel housing
liner in area of turn signal repeater ⇒ Rep. gr. 66 .
– Press down retainers -arrows- at turn signal housing -1- and
carefully take turn signal out of opening in wing.
– Unplug electrical connector -2-.
Note
Turn signal repeater must be renewed as a complete unit if LED
is defective.
Installing
Install in reverse order.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
9. Turn signal repeaters - vehicles up to 08.2007 207
To Next Page
Loading...
