Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
5.10 Renewing bulb for daytime running light
Removing
WARNING
High voltage! Danger to life!
♦ Ensure that any part of the gas discharge headlights
marked with yellow high-voltage warning symbols are de-
energised when you are working on them.
♦ Switch off ignition and all electrical equipment and remove
ignition key.
♦ Do not flash the headlights.
– Turn light switch to position “0”.
– Switch off ignition and all electrical equipment and remove ig‐
nition key.
– Do not flash the headlights.
Headlight (left-side) - vehicles with 6-cyl. or 8-cyl. engine:
– Remove power steering reservoir ⇒ page 182 .
Headlight (left-side) - vehicles with 12-cyl. engine:
– Remove air cleaner housing ⇒ page 184 .
Headlight (right-side) - vehicles with 6-cyl. or 8-cyl. engine:
– Remove air cleaner (top section) ⇒ page 183 .
Headlight (right-side) - vehicles with 12-cyl. engine:
– Remove air cleaner housing ⇒ page 184 .
All vehicles (continued):
– Release retaining tabs -arrows- and detach main beam hous‐
ing cover from headlight housing.
– Turn bulb holder anti-clockwise -arrow- and pull out of head‐
light housing.
Installing
Installation is carried out in the reverse order; note the following:
– Insert new bulb in bulb holder, taking care not to touch glass
bulb with bare hands.
– Secure bulb holder by turning clockwise.
– Close housing cover.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
190 Rep. gr.94 - Lights, bulbs, switches - exterior
To Next Page
Loading...
