Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
16 - Dipped beam housing cover
17 - Turn signal bulb
❑ 12 V, 16 W
❑ 2x
❑ Orange
❑ Renewing bulb ⇒ page 145
18 - 6 Nm
19 - Bracket for headlight housing
3.2 Removing and installing headlights
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
– Remove front bumper cover ⇒ Rep. gr. 63 .
– Unscrew bolts -1- and -3 ... 5-.
– Unplug electrical connector -2-.
– Detach headlight to front.
Installing
Installation is carried out in the reverse order; note the following:
– Check adjuster nut -4- of adjuster for freedom of movement
-arrows-.
– Screw down adjuster nut as far as it will go, but do not tighten.
– Insert headlight.
– Install front bumper cover ⇒ Rep. gr. 63 .
– Align headlight with body contours (gap widths).
Note
Headlight can be aligned by slackening off bolts -1 … 3- and al‐
tering height of holders.
Note
Headlight can be aligned at top edge by slackening off both bolts
-arrows- and swivelling headlight housing.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Halogen headlights (USA vehicles) 139
To Next Page
Loading...
