Audi 2003 A8 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove starter unit for gas discharge bulb: vehicles up to
08.2007 ⇒ page 159 , vehicles from 09.2007 onwards
⇒ page 161 .
– Disengage retaining clips -1-.
– Pull gas discharge bulb -2- out of headlight housing.
Installing
Installation is carried out in the reverse order; note the following:
– Insert new gas discharge bulb in housing; do not touch glass
part of bulb with bare hands.
Note
Note correct installation position: lug at top of bulb holder must
engage in recess of gas discharge bulb.
– Secure gas discharge bulb with retaining clip.
– Install starter unit for gas discharge bulb: vehicles up to
08.2007 ⇒ page 159 , vehicles from 09.2007 onwards
⇒ page 161 .
4.7 Removing and installing starter unit for
gas discharge bulb - vehicles up to
08.2007
Removing
WARNING
High voltage! Danger to life!
♦ Ensure that any part of the gas discharge headlights
marked with yellow high-voltage warning symbols are de-
energised when you are working on them.
♦ Switch off ignition and all electrical equipment and remove
ignition key.
♦ Do not flash the headlights.
– Turn light switch to position “0”.
– Switch off ignition and all electrical equipment and remove ig‐
nition key.
– Do not flash the headlights.
– Remove appropriate front wheel.
– Remove relevant front wheel housing liner ⇒ Rep. gr. 66 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
4. Gas discharge headlights 159

Audi 2003 A8 Specifications

General

Brand	Audi
Model	2003 A8
Category	Automobile
Language	English