Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7 Fog lights - vehicles up to 08.2007
7.1 Removing and installing fog lights - Audi
A8
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
– Pull out air inlet grille in lower section of bumper cover
-arrows-.
– Unscrew bolts -arrows- and take fog light housing out of bump‐
er cover.
– Unplug electrical connector.
Installing
Installation is carried out in the reverse order; note the following:
– Adjust fog lights ⇒ page 204 .
Tightening torque
Component Nm
Fog light housing to bumper cover 2.3
7.2 Renewing fog light bulb - Audi A8 up to
09.2004
Removing
– Remove fog light ⇒ page 201 .
– Unplug electrical connector -1- at bulb.
– Turn bulb -2- anti-clockwise -arrow- and pull it out of fog light
housing.
Installing
Installation is carried out in the reverse order; note the following:
– Do not touch glass bulb with bare hands.
– Secure bulb by turning in clockwise direction.
– Adjust fog lights ⇒ page 204 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
7. Fog lights - vehicles up to 08.2007 201